Barco CTPN-41B Manual de usuario descargar pdf (Pagina 53)

english

6.12 Software upgrades

When upgrading the software the projector must always be in standby position!

If you are or have been in ECO mode you MUST use the following procedure before

upgrading your projector:

1. Start the projector

2. Disable the OSD mode in the OSD menu

3. Power off (enters standby and not ECO mode)

4. Disconnect and reconnect the power cable

5. Wait for standby (yellow light)

6. Connect USB cable and proceed with the uprading process below

In order to upgrade your projector, please follow the method and sequence described

below:

1. You will need a USB memory stick set up with a FAT-ﬁle system to perform this upgrade

2. Access the upgrade software from the following web-address;

www.barco.com

3. Download and save the ﬁrmware.zip-ﬁle to your PC desktop

4. Download and save the ﬁrmware_<version>.tar ﬁle to the root of a memory stick

It is important that the USB is safely removed from computer, using the eject

function on your PC.

5. Set the projector in standby mode

6. Insert the memory stick in the projector and wait a few seconds

7. If the projector is in standby mode it will start ﬂashing automatically

If the projector is in a sleep mode, push the on button to initiate ﬂashing

Rapid blue blinking indicates that upgrade is initiated

8. Remove the USB stick when blue blinking turns to yellow blink.

Rapid yellow blinking indicates that the upgrade process is running

9. Do not turn off projector/remove the power cable while the upgrade is still in

progress!

10. The projector may restart several times during the upgrade

11. The upgrade has ﬁnished successfully when yellow rapid blink has changed to stable

yellow light

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 67 68

Sin comentarios

Barco CTPN-41B Manual de usuario Pagina 53