Barco DC Toolset Manual de usuario descargar pdf (Pagina 32)

4. Configurator

4.5 Add device to a co nﬁguration

This chapter describes how to add a device, projector or touch pan el to a conﬁguration

without scanning the complete network for all possible devices.

Overview

• Add device

• General properties

• Set up a Ethernet connection

• Decorator setup

4.5.1 Add device

The possible device types depends on the installed plug-ins.

About adding a device

To make it more easy to ﬁnd back a device, projector or touch panel while adding it to the software, the

different devices are grouped in categories.

The following categories are available for the moment (depending on the loaded pl

ug-ins):

• Digital cinema: contains all supported digital cinema projectors.

• Digital cinema, contains all supported touch panels (DCTP)

How to add

1. Click Conﬁguration on the menu and select Add (a). (image 4-4)

2. Move the cursor to the right and select the desired category.

3. Move the cursor again to right and select the desired projector.

The Create projector dialog box opens with the selected device type pictograph at the right side (b).

4. Enter the different device properties such as the projector identiﬁcation, the connection parameters and

projector decorator for the conﬁguration preview.

R59770449 DC TOOLSET 15/12/2009

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 78 79

Sin comentarios

Barco DC Toolset Manual de usuario Pagina 32